Table of Contents
Advertisement
2.
Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from
the chassis.
5.
Lift the cover from the chassis.
2.1.3.
Installing.the.top.cover
1.
Position the cover on top of the
chassis with the thumbscrews on the
rear, and leaving a gap of about half
an inch from the front panel.
2.
Make sure that the side markings
on the cover (two on each side)
are aligned to the grooves on the
chassis.
3.
Slide the cover toward the front until it snaps in place.
4.
Tighten the thumbscrews on the rear to secure the cover.
2-4
1/2 inch
distance
Thumbscrews
Chapter 2: Hardware setup
Side markings
Grooves
Advertisement
Table of Contents
