Table of Contents
Advertisement
Memory.Sparing.:.
At configuration time, a DIMM rank is set aside to replace a defective DIMM rank.
When the error rate for a failing DIMM rank reaches a pre-determined threshold,
the memory sparing function will issue an interrupt and initiate a spare copy. At the
completion of the copy, the failing DIMM rank is disabled and the "spared" DIMM
rank will be used in its place. Refer to 5.4.2 Chipset Configuration and configure
the options of.Branch.0.Rank.Sparing to enable the memory sparing functions.
And the default BIOS setting is disabled.
•
Each branch contains its own sparing engine and can be enabled or
disabled separately.
•
This motherboard does not support rank sparing across branches.
•
This motherboard does not support rank sparing when in mirror mode.
•
The DIMM rank with the largest size will be assigned as spare rank. Data
can only be copied from a smaller sized rank to a larger sized one.
•
A DIMM can contain only one or two ranks. To support sparing function, a
DIMM channel should contain at least two ranks.
•
When sparing function is enabled, the usable memory size will reduce then
size of the spare ranks.
The following tables show memory configurrations with Memory Sparing function in
Branch 0.
One DIMM per channel (Dual ranks)
Branch0
Memory.space
Total.Memory
2-12
Channel.0
DIMM_00.
(2048MB/2.Ranks)
Rank 0
(1024 MB)
Sparing
1024 MB
Channel.1
DIMM_10.
(2048MB/2.Ranks)
Rank 1
Rank 0
(1024 MB)
(1024 MB)
V
1024 MB
2048 MB
Chapter 2: Hardware setup
Rank 1
(1024 MB)
V
Advertisement
Table of Contents
