Asus Hummingbird User Manual page 32

2. CPU Fan and Chassis Fan control setting
(3-pin F_FAN_SEL1, R_FAN_SEL1)
These jumpers allow you to switch for fan pin selection. The F_FAN_SEL1
jumper is for the front fans control and the R_FAN_SEL1 jumper is for the
rear fans control. Set to pins 1–2 when using 4-pin fans or pins 2–3 when
using 3-pin fans.
•
•
IPMI setting (3-pin IPMI_SEL1) (Hummingbird model only)
3.
This jumper allows you to use the IPMI feature through the dedicated LAN
or share LAN. Place the jumper caps on pins 1–2 if you want to use IPMI
through the dedicated LAN (default). Or you can place the jumper caps on
pins 2–3 to use IPMI through the shared LAN.
2-16
If you use a 4-pin fan but set the jumper to pin 2-3, the fan you installed
may not work.
If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan control will
not work and the fan you installed will always run at full speed.
Chapter 2: Hardware information