Chapter 4 Secondary Lan Port On Primepower250/450; Outline; Notes; How To Set Configuration Information - Fujitsu PRIMEPOWER B23Q8YA-G-02-E Hardware Platform Manual

Chapter 4 Secondary LAN port on
PRIMEPOWER250/450
This chapter describes how to use the secondary LAN (10/100/1000Mbps) port on PRIMEPOWER250/450.
4.1

Outline

The secondary LAN port on PRIMEPOWER250/450 is controlled by FUJITSU PCI Gigabit Ethernet
Driver (Interface name is "fjgi") included in Solaris 10.
4.2

Notes

When using 1000 Mbps communication, be sure to set Autonegation to 'on'.
If using the PCI card (PW008GE4/PW008GE5/PW008QG1), please refer to the User's guide attached
with the PCI card.
4.3

How to Set Configuration Information

This section describes required setting to use a fjgi interface.

4.3.1 Environment Setting

This section describes how to edit files required to build environment.
4.3.1.1

Determining the Client Name of Target Driver

1. To use the secondary LAN port as an IPv4 interface:
To allocate the IP address or hostname to the fjgi interface, edit /etc/hostname.fjgi* (* is an numerical
value) file. About netmask value, please see "4.3.1.3 Defining Netmask Value" .
Example /etc/hostname.fjgi*:
Define the unique hostname:
giga-v4
or, define the IP address:
192.168.150.1
Note: If you defined the hostname in hostname.fjgi* file, see the section "4.3.1.2 Defining Hostname "
for detailed information.
2. To use the secondary LAN port as an IPv6 interface
To allocate the IP address and prefix to the fjgi interface, edit /etc/hostname6.fjgi* (* is an numerical
value) file.
15