Fujitsu PRIMEPOWER B23Q8YA-G-02-E Hardware Platform Manual page 23

Table 4.1 Parameters List
Parameter
name
parent
unit-address
AutoNegotiation_A
LinkSpeed_A
DuplexCapabilities_A
FlowControl_A
Value
fjgi
FJSV,pgtb
FJSV,pgsb
Please refer to "4.3.2.1.2 How to Set
Parameter".
Please refer to "4.3.2.1.2 How to Set
Parameter".
On (Default)
Off
Auto (Default)
1000
100
10
Both (Default)
Half
Full
Auto (Default)
Rem
LocSend
None
Description
When using PRIMEPOWER250/450
secondary LAN port, please set
name="fjgi".
When using PCI card PW008GE5,
please set name="FJSV,pgtb".
When using PCI card PW008GE4,
please set name="FJSV,pgsb".
The location of the device node in a
device tree is specified.
The address within a device node is
specified.
AutoNegotiation is enabled. (In this
setting, unable to connect to the
remote device of a fixed mode.)
When you use 1000Mbps, please use
in Autonegotiation_A="On" (default)
mode.
AutoNegotiation is disabled. (Fixed
mode)
Connect in 1000/100/10Mbps by the
connection partner.(This can be set
when AutoNegotiation_A="On".)
Connect in 1000Mbps.
Connect in 100Mbps.
Connect in 10Mbps.
Indicating that both Full-Duplex and
Half-Duplex are being supported.
(This can be set
AutoNegotiation_A="On".)
Half-Duplex operation is allowed.
Full-Duplex operation is allowed.
A flow control is performed according
to a setup of partner equipment.
Only the flow control from the remote
machine is allowed. The flow control
to the remote machine is not allowed.
Only the flow control from the main
unit is allowed. The flow control from
the remote machine is not allowed.
Flow control is disabled.
when
17