Making Prints Lighter Or Darker - Brother PJ673-K Manual

Chapter 2
NOTE
• Make sure that the bottom edge of the
paper is parallel with the roller.
• Only one side of the paper can be printed
on. Check the paper, and load it so that
the smooth, coated side faces down (see
Tips on Using Paper on page 39).
1
1 Print surface
f
If necessary, change the print settings
using either the printer driver (see
Setting Printer Driver Options
on page 35) or PJ-673 Utility (see
Brother PJ-673 Utility on page 40).
g
Print from each application.
The DATA indicator blinks in green to
indicate that the printer is receiving data,
and the document is printed.
34
NOTE
• If paper is loaded and the DATA indicator
remains green without blinking, the printer
has not received enough data to print an
entire page. Press and hold the
(Feed) button to print and eject the
page.
• The paper can be loaded after the print job
has been sent. If the paper is skewed after
the printer pulls it into the starting position,
open the release cover completely,
remove the paper, and then close the
cover and load the paper again (see
Clearing a Paper Jam on page 39).
Making Prints Lighter or
Darker
You can make prints lighter or darker by
adjusting the print density setting in the
printer driver's dialog box (see Setting Printer
Driver Options on page 35) or PJ-673 Utility
(see Print Density on page 48).
When using the battery, changing the print
density setting may result in slight changes in
printing speed and the number of pages that
can be printed on a single charge.
2