Using The Rechargeable Ni-Mh Battery (Optional); Installing The Rechargeable Ni-Mh Battery - Brother PJ673-K Manual

Using the
Rechargeable Ni-MH
Battery (Optional)
Installing the Rechargeable
Ni-MH Battery
a
Open the battery cover (1) by pressing
the cover latch (2).
1 Battery cover
2 Cover latch
b
Swing the cover open and remove it.
c
Check the orientation of the battery
connector, and then gently insert the
connector (4) into the terminal (3) on the
inside of the battery compartment.
3
4
3 Terminal
4 Battery connector
1
1
1
2
Setting Up the Printer
NOTE
With the printer positioned as shown
below, the red wire of the battery
connector (4) will be on the left side.
d
Grasp the battery removal ribbon, which
is attached to the inside of the battery
compartment. Make sure that enough
ribbon is exposed after the rechargeable
Ni-MH battery installed so that you can
pull the ribbon to remove the battery.
e
While holding onto the ribbon, tilt the
rechargeable Ni-MH battery and insert it
into the battery compartment. After the
rechargeable Ni-MH battery passes the
outer edges of the compartment, press it
securely into position.
NOTE
• Make sure that the side of the
rechargeable Ni-MH battery marked
"Ni-MH" faces away from the battery
compartment, otherwise the battery cover
will not close properly.
• The rechargeable Ni-MH battery contains
a heat sensor that stops the flow of
electricity if the battery overheats.
f
Attach the battery cover to the end of the
battery compartment opposite the
AC/DC connector. Close and latch the
cover. If necessary, gently push the
cover latch towards the AC/DC
connector until it latches.
NOTE
• Be careful that you do not pinch the
battery connector cord.
• The voltage supplied by the rechargeable
Ni-MH battery fluctuates. The printing
speed may also fluctuate depending on
the voltage.
1
3