Important Alert Items - Fujitsu MCE3064AP Product Manual

Important Alert Messages
The important alert messages in this manual are as follows:
Task
Operation
Installation
vi

Important Alert Items

A hazardous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. This alert signal also indicates
that damages to the product or other property, may occur if the user does not
perform the procedure correctly.
Low temperature burns
The surface temperatures of some ICs on the printed circuit board
unit in the optical disk drive exceed 55°C while operating. Be
careful of low tenperature burns.
Device damage
1) Shock or vibration applied to the drive that exceeds the values
defined in the standard damage the drive. Use care when
unpacking.
2) Do not leave the drive in dirty or contaminated environments.
3) Since static discharge may destroy the CMOS devices in the
drive, pay attention to the following points after unpacking:
• Use an antistatic mat and wrist strap when handling the
drive.
• Hold the mounting frame when handling the drive. Do
not touch the PCA except when setting the switches.
4) When handling the drive, hold both sides of the mounting
frame. When touching other than both sides of the mounting
frame, avoid putting force.
5) Do not forcibly push up the end of the header pin of the printed
circuit board unit when handling or setting the drive.
C156-E142-02EN
Alert message Page
3-1
3-17