Error Code - Fujitsu MCE3064AP Product Manual

When the Valid bit is 1, the information field (bytes 3 to 6) is effective.
Error Code indicates the sense data format and type. See Table 4.96.

Error Code

X'70' (Current error)
X'71' (Deferred error)
Sense Key outlines the error. The definition of Sense Key is listed in Table 4.97.
Sense Key Abbreviation
0h NO SENSE
1h RECOVERED ERROR
2h NOT READY
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
7h DATA PROTECT
8h BLANK CHECK
9h-Ah Reserved
Bh ABORTED COMMAND
Ch-Fh Reserved
Table 4.96 Error code
Reported for a normal error.
Reported when an error occurs in the command that accesses the
write cache when the write cache is enabled. If this sense data is
reported, the command that reported the Check Condition status is
not executed.
Table 4.97 Sense key
Indicates there is no sense key to be reported. NO SENSE is
set when a command ends normally.
Indicates that recovery ends successfully or that the
command ends normally using the internal default value
even if invalid data is detected in command parameters.
(Not reported when the PER bit is 0.)
Indicates that access with an access command cannot be
executed.
Indicates that an unrecoverable error is detected due to
media failure.
Indicates that an unrecoverable error is detected due to
hardware failure.
Indicates that command packets or command parameters
contains invalid data. Media data remains unchanged.
Indicates that reset, power-on, or media exchange is caused.
Indicates that media is write-protected with the Write Protect
key.
Indicates that a blank sector is detected. Not used
Not used
Indicates that the command is interrupted.
Not used
C156-E142-02EN
Report timing
Definition
4 - 63