When An Error Message Appears - Canon Color imageCLASS MF8280Cw Settings Manual


• You should press the WPS button within 2
minutes after you select <Yes> in step
• Press and hold* the button until the WPS lamp
lights or blinks.
* The time that you should hold the button may vary
depending on the wireless router you are using.
Move to the machine
8
• After the <Connected.> screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on.
Wait approximately 2 minutes
after the connection is completed.
The IP address is set during this time period.
Proceed to P. 9
1
Prepare for Wireless LAN Connection

When an error message appears:

Press [OK] to close the screen, check whether
or not the WPS function of the wireless router is
correctly set, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
.
6
When checking the network connection:
You can check if the machine is properly connected
to the network using a computer that is connected
to the same network.
When setting an IP address manually:
2
Setting the Wireless LAN
Setting the Wireless LAN
"When an Error Message Appears" (P.14)
"Checking that the Wireless LAN Setting is
Completed" (P.9)
"Setting IP Addresses" in the e-Manual
3 4
Installing the Software
5
Troubleshooting