Properties
Tab: Device Settings
Collate: (PCL driver only)
For collating copies of a multiple page
print job there are two possibilities.
Attention
If you use 'Separation' or 'Staple' feature there is a limitation using setting 'Programme'.
'Collate -> Programme' sends all copies in one whole print job. In this case the printer cannot
separate each copy. Also the printer will staple the whole print job not each copy.
'Collate -> Printer' sends a copy collate command for the print job. In this case the printer
knows where to separate and/or staple each copy.
'Paper Feeder:' and 'Duplex Unit (...):' should
be set-up at installation time (Vista and newer). If
not please make the correct settings here.
'Printer Memory:' please does the choice that
fits best to your printer.
Printer (im Drucker (RAM-Disk / HDD))
Using the collate feature you must enable the
RAM disk of the printer or install a HD/MD drive
to your printer. This feature will decrease the size
of the print-job.
Programme (vom Programm)
Some printers do not allow RAM disk or the
usage of a HD/MD disk. In this case you can use
the extended print functions of Windows. Several
programmes support this software collate
feature. This feature will increase the size of the
print-job.
Page 2 - 11
Need help?
Do you have a question about the FS C5030N - Color LED Printer and is the answer not in the manual?