Federal Communication Commission Interference Statement; Rohs; Europe - Eu Declaration Of Conformity - TRENDnet TPL-4052E User Manual

TPL-4052E User's Guide

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
© Copyright 2013 TRENDnet. All rights reserved.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The availability of some specific channels and/or operational frequency bands
are country dependent and are firmware programmed at the factory to match
the intended destination. The firmware setting is not accessible by the end
user�

RoHS

This product is RoHS compliant.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the Directive
2004/108/EC, /2006/95/EC and 2009/125/EC:
EN55022 : 2010, class B
EN 61000-6-3 : 2007 + A1 :2011
EN 61000-3-2 : 20086 + A1 : 2009 + A2 : 2009,
class A
EN 61000-3-3 : 2008
EN 50412-2-1 :2005, class 1, type 2
EN 60950-1 :2006 + A11 : 2009 + A1 : 2010 + A2 : 2011 : Safety of Information Technology Equipment
including electrical business equipment
Declaration of Conformity
25