File Menu; Security Menu - HP ProBook 5320m - Notebook PC User Manual

File menu

Select
System Information
Restore Defaults
Reset BIOS security to factory default
Ignore Changes and Exit
Save Changes and Exit

Security menu

NOTE: Some of the menu items listed in this section may not be supported by your computer.
Select
Setup BIOS Administrator Password
User Management (requires a BIOS administrator password)
Password Policy (requires a BIOS administrator password)
HP SpareKey
Always Prompt for HP SpareKey Enrollment
Fingerprint Reset on Reboot (If Present)
Allow reset of HP ProtectTools security keys
Change Password
HP SpareKey Enrollment
DriveLock Passwords
120 Chapter 15 Computer Setup
To do this
● View identification information for the computer and the
batteries in the system.
●
View specification information for the processor, memory
size, system ROM, video revision, keyboard controller
version, and wireless identification numbers.
Replace the configuration settings in Computer Setup with the
original factory settings. (Hard drive mode, password settings,
and security settings are not changed when you restore the
factory settings.)
Resets password to the factory default in case of a forgotten
password.
Cancel any changes entered during the current session. Then
exit and restart the computer.
Save any changes entered during the current session. Then
exit and restart the computer. Your changes go into effect
when the computer restarts.
To do this
Set up a BIOS administrator password.
● Create a new BIOS user account.
●
View a list of ProtectTools users.
Revise password policy criteria.
Enable/disable HP SpareKey (enabled by default).
Enable/disable HP SpareKey enrollment (enabled by default).
Reset/clear the fingerprint reader ownership (select models
only; disabled by default).
Enable/disable reset of HP ProtectTools security keys.
Enter, change, or delete a BIOS administrator password.
Enroll or reset HP SpareKey, which is a set of security
questions and answers used if you forget your password.
●
Enable/disable DriveLock on any computer hard drive
(enabled by default).
● Change a DriveLock user password or master password.
NOTE: DriveLock settings are accessible only when you
enter Computer Setup by turning on (not restarting) the
computer.