Power Connector Cable - HP Pavilion dv3-4100 - Entertainment Notebook PC Maintenance And Service Manual

Power connector cable

NOTE: The power connector cable is included in the Cable Kit, spare part number 603924-001.
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Memory module/wireless module compartment cover (see
b. Optical drive (see
c. Top cover (see
d. USB board (see
Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Release the power cable from the clips(2) built into the base enclosure.
3. Remove the two Phillips PM2.5×5.0 screws (3) that secure the power connector and bracket to
the base enclosure.
4. Remove the power connector bracket (4). The power connector bracket is included in the
Bracket Kit, spare part number 603925-001.
5. Release the power connector (5) from the clip built into the base enclosure.
Reverse this procedure to install the power connector cable.
Battery on page 38), and then remove the following components:
Optical drive on page
Top cover on page 51)
USB board on page 60)
Memory module on page
50).
Component replacement procedures
39)
61