Removing A Power Supply - Dell PowerEdge VRTX Owner's Manual

Figure 27. Removing and Installing a Power Supply Blank
1. power supply blank
To install the power supply blank, align the blank with the power supply bay and insert it into the chassis until it clicks
into place.

Removing A Power Supply

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE: The power supplies are hot-swappable. Remove and replace only one power supply at a time in a system
that is turned on.
NOTE: In systems that ship with the wheel assembly, a power cable retention bracket is used to route the power
cable from the power supply.
1. Disconnect the power cable from the power source and the power supply you intend to remove.
a) In systems without the wheel assembly installed, remove the power cable from the cable strap.
b) In systems with the wheel assembly installed, remove the power cable from the power cable retention bracket
slot.
2. Press the release latch and slide the power supply out of the chassis.
50