Configuring A Server Module - Dell PowerEdge VRTX Owner's Manual

Figure 26. Removing and Installing a Server Module
1. release button
2. PCIe label on server module
NOTE: This label indicates that the
server module is configured specifically
for the VRTX enclosure.

Configuring A Server Module

NOTE: Follow this procedure to install PowerEdge M520 or M620 server modules that are not configured for the
VRTX enclosure.
NOTE: If you install PowerEdge M520 or M620 server modules that are not configured for the VRTX enclosure, an
error message is displayed.
To configure a server module for the VRTX enclosure:
1. Open the server module.
For more information on opening a server module, see the server module's Owner's Manual at dell.com/
poweredgemanuals.
2. Remove any mezzanine cards installed in Fabric B and Fabric C slots of the server module.
3. Install PCIe Mezzanine cards in the vacant Fabric B and Fabric C slots.
For more information on installing the PCIe Mezzanine cards, see the server module's Owner's Manual at dell.com/
poweredgemanuals.
48
3. guide rail on server module (or server module
blank)
4. guide rail on enclosure
5. server module handle