Removing The Low Profile Expansion Card Divider Unit - Dell PowerEdge VRTX Owner's Manual

Vrtx enclosure owner's manual
Hide thumbs Also See for PowerEdge VRTX:
Table of Contents

Advertisement

4.
Lift the expansion-card latch out of the chassis slot.
5.
Remove the filler bracket.
6.
Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion-card
connector.
7.
Align the expansion-card bracket with the metal standoff on the chassis.
8.
Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated.
9.
Close the expansion-card latch.
10. If applicable, connect cables to the expansion card.
11. Close the system.
12. Map the expansion card to the server module using the CMC (if not already mapped).
13. Turn on the server module using the operating system commands or the CMC.
14. Install any device drivers required for the card as described in the documentation for the card.

Removing The Low Profile Expansion Card Divider Unit

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
If installed, remove the front bezel.
2.
Turn off the server modules using the operating system commands or the CMC.
3.
Turn off the enclosure, including any attached peripherals, and disconnect the enclosure from the electrical outlet
and peripherals.
4.
To reduce the chassis weight, remove the following (if required):
a) hard drives
b) server modules
c) power supplies
5.
If applicable, rotate the system feet inward and lay the system on its side on a flat stable surface, with the cover
release latch side on top.
6.
Open the system.
7.
If applicable, remove the low profile expansion cards.
8.
Remove the five screws securing the expansion-card divider unit to the chassis.
9.
Holding it by its sides, lift the divider unit up and away from the chassis.
76

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents