Installing A Server Module; Power Supplies; Power Supply Blanks - Dell PowerEdge VRTX Owner's Manual

4. Ensure that no tools or parts are left inside the server module.
5. Slide the cover on the server module until it clicks into position.
A properly seated cover is flush with the surface of the server module chassis.
6. Install the latest iDRAC Enterprise license. For more information, see
manuals.

Installing A Server Module

Your system supports Dell PowerEdge M520 and M620 server modules that are specifically configured for the VRTX
enclosure, and can be identified by a label marked PCIe on the top of the server module.
1. If you are installing a new server module, remove the plastic cover from the I/O connector(s) and save for future
use.
2. If applicable, configure the server module. For more information, see
3. Orient the server module so that the module handle is on the left side of the server module.
4. Align the server module with the server module slot and guide rails on the enclosure.
5. Using both hands, slide the server module into the enclosure until the module release handle engages and locks
the server module in place.
6. If applicable, reinstall the front bezel.

Power Supplies

Your system supports up to four 1100 W AC power supplies in 1+1, 2+1, 3+1, and 2+2 redundant configurations.
NOTE: All power supplies must be of the same type and have the same maximum output power.
NOTE: In the 2+2 redundant configuration, PSU1 and PSU2 are connected to one grid, and PSU3 and PSU4 are
connected to another grid.

Power Supply Blanks

If the enclosure is operated with less than four power supplies, power supply blanks must be installed in the unoccupied
power supply bays to maintain proper cooling airflow in the enclosure.
To remove the power supply blank in the bay, pull outward on the blank.
iDRAC7 User's Guide , at dell.com/support/
Configuring A Server Module.
49