Dell PowerEdge VRTX User Manual page 81

Setting
Enable iDRAC IPMI over LAN
Enable iDRAC IPv4 DHCP
Starting iDRAC IPv4 Address (Slot 1)
iDRAC IPv4 Netmask
iDRAC IPv4 Gateway
Enable iDRAC IPv6
Enable iDRAC IPv6 Autoconfiguration
iDRAC IPv6 Gateway
iDRAC IPv6 Prefix Length
3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click
Apply iDRAC Network Settings to deploy the settings to the iDRAC.
The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If Set iDRAC Root
Password on Server Insertion and QuickDeploy Enabled are enabled, the user is prompted using the LCD interface
Description
Enables or disables the IPMI over LAN channel for each
iDRAC present in the chassis. By default, this option is
selected.
Enables or disables DHCP for each iDRAC present in the
chassis. If this option is enabled, the fields QuickDeploy
IP, QuickDeploy Subnet Mask, and QuickDeploy
Gateway are disabled, and cannot be modified since
DHCP is used to automatically assign these settings for
each iDRAC. To select this option, you must select the
Enable iDRAC IPv4 option.
Specifies the static IP address of iDRAC in the server, in
slot 1 of the enclosure. The IP address of each
subsequent iDRAC is incremented by 1 for each slot
from slot 1's static IP address. In the case where the IP
address plus the slot number is greater than the subnet
mask, an error message is displayed.
NOTE: The subnet mask and the gateway are not
incremented such as the IP address.
For example, if the starting IP address is
192.168.0.250 and the subnet mask is
255.255.0.0 then the QuickDeploy IP address for
slot 15 is 192.168.0.265. If the subnet mask is
255.255.255.0, the QuickDeploy IP
address range is not fully within
QuickDeploy Subnet error message is displayed
when you click Save QuickDeploy Settings or Auto-
Populate Using QuickDeploy Settings.
Specifies the QuickDeploy subnet mask that is assigned
to all newly inserted servers.
Specifies the QuickDeploy default gateway that is
assigned to all the DRAC present in the chassis.
Enables IPv6 addressing for each iDRAC present in the
chassis that is IPv6 capable.
Enables the iDRAC to obtain IPv6 settings (address and
prefix length) from a DHCPv6 server and also enables
stateless address auto configuration. By default, this
option is enabled.
Specifies the default IPv6 gateway to be assigned to the
iDRACs. The default value is "::".
Specifies the prefix length to be assigned for the IPv6
addresses on the iDRAC. The default value is 64.
81