Viewing And Modifying Cmc Network Lan Settings Using Cmc Web Interface; Viewing And Modifying Cmc Network Lan Settings Using Racadm; Enabling The Cmc Network Interface - Dell PowerEdge VRTX User Manual

NOTE: You must have Chassis Configuration Administrator privilege to set up CMC network settings.

Viewing and Modifying CMC Network LAN Settings Using CMC Web Interface

To view and modify the CMC LAN network settings using CMC Web interface:
1. In the left pane, click Chassis Overview, and then click Network. The Network Configuration page displays the
current network settings.
2. Modify the general, IPv4, or IPv6 settings as required. For more information, see the
3. Click Apply Changes for each section to apply the settings.

Viewing and Modifying CMC Network LAN Settings Using RACADM

To view IPv4 settings, use the following subcommands and objects:
•
getniccfg
•
getconfig
• cfgCurrentLanNetworking
To view IPv6 settings, use the following subcommands and objects:
•
getconfig
• cfgIpv6LanNetworking
To view IPv4 and IPv6 addressing information for the chassis, use the getsysinfo subcommand.
For more information about the subcommands and objects, see the
VRTX RACADM Command Line Reference Guide .

Enabling the CMC Network Interface

To enable or disable the CMC network interface for both IPv4 and IPv6, type:
racadm config -g cfgLanNetworking -o cfgNicEnable 1
racadm config -g cfgLanNetworking -o cfgNicEnable 0
NOTE: The CMC NIC is enabled by default.
To enable or disable the CMC IPv4 addressing, type:
racadm config -g cfgLanNetworking -o cfgNicIPv4Enable
1
racadm config -g cfgLanNetworking -o cfgNicIPv4Enable
0
NOTE: The CMC IPv4 addressing is enabled by default.
To enable or disable the CMC IPv6 addressing, type:
racadm config -g cfgIpv6LanNetworking -o cfgIPv6Enable
1
racadm config -g cfgIpv6LanNetworking -o cfgIPv6Enable
0
NOTE: The CMC IPv6 addressing is disabled by default.
64
Online Help .
Chassis Management Controller for PowerEdge