Panasonic KX-WT125 Operating Instructions Manual page 69

Problem
The handset
stops working
during operation.
You cannot use
the handset
during a power
failure.
The headset
does not work.
Noise is
frequently heard.
Two short beeps
are heard during
a conversation.
You charged
the batteries
for 7 hours, but
the beep tones
sound, and
flashes (needs to
be charged) after
a few telephone
calls.
While charging
the batteries, the
handset and the
AC adaptor feel
warm.
Troubleshooting and Error Messages
Possible Cause
The handset will not
function during a power
failure because the PBX
stops emitting radiowaves.
A headset tone cannot be
heard when receiving an
incoming call when the
headset is attached.
The radio signal is weak.
The battery charge
contacts may be dirty.
It is time to change the
batteries.
These are normal
conditions.
Solution
Re-insert the batteries and
try again.
(See "Battery Installation" on
page 5.)
• Make sure the headset
ringer setting is set to
"On". (See "Incoming
Option" on page 59.)
• Make sure the headset
jack is connected
properly. (See "Location of
Controls" on page 8.)
• Place the handset and CS
away from other electrical
appliances.
• Move closer to the CS.
Move closer to the CS.
Clean the battery charge
contacts without damaging
them and charge once more.
Replace with new batteries.
69