Power Requirements; Agency Compliance - Dell Force10 S25-01-GE-24P Manual

Power Requirements

Parameter
Nominal Input Voltage
Maximum Current Draw
Minimum AC Current Draw
Maximum Power Consumption
Note: S25P and S25P-DC switches contain a lithium battery. The switch contains no user-serviceable
parts. For details on recycling the switch or any of its components, see
page 36.

Agency Compliance

The S25P is designed to comply with the following safety and agency requirements.
USA Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC rules. These limits are designated to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case users will be required to take
whatever measures necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits.
Force10 Networks is not responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorized changes or modifications in the equipment.
Unauthorized changes or modification could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Canadian Department of Communication Statement
European Union EMC Directive Conformance Statement
This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on
the approximation of the laws of the Member States relating to electromagnetic compatibility. Force 10
34
Specifications
S25P: 90 – 254 VAC, 47/63 Hz
S25P-DC: -48 VDC
S25P: 2 A @ 100/120 VAC; 1 A @ 200/240 VAC
S25P-DC: 3.6 A @ -48 VDC
.25 A @ 254 VAC
.56 A @ 90 VAC
S25P: 90W
S25P-DC: 77W
Product Recycling and Disposal on
S25P Specifications