Setting Up Your Network Infrastructure For Fcoe; Figure 1. Network Infrastructure Diagram - Dell Wyse R Class Manual

Implementing FCoE in the Linux Operating System

Setting up your network infrastructure for FCoE

Perform the following steps to set up your network infrastructure for FCoE. While performing these
steps, refer to the network diagram in Figure 1.
1. Set up in NPIV mode and enable the FCoE feature on the Cisco Nexus 5020 distribution switch.
From the Global Configuration Mode of the distribution switch, run the following commands:
feature fcoe
feature lcap
feature lldp
feature npiv
Figure 1. Network infrastructure diagram.
7