Setting Up Fcoe For Sles 11 Sp 2; Installing / Verifying Fcoe Support; Figure 5. Fcoe Support Not Installed - Dell Wyse R Class Manual

Implementing FCoE in the Linux Operating System

Setting up FCoE for SLES 11 SP 2

Installing / verifying FCoE support

If FCoE support has not been installed in SLES 11 SP2, it must be installed. To verify if FCoE support
was installed in SLES 11 SP2, perform the following steps:
1. Log-in as root, then the start YaST2 Control Center by running the yast command. From
YaST2, select Network Services in the left-side menu, then use the Tab key switch to the
right-side menu. Use the arrow keys to scroll up and down the list of Network Services and
look for FCoE Client Configuration ; if FCoE Client Configuration is not listed, as
in Figure 5, then FCoE support is not installed in SLES 11 SP2, and must be installed at this
time.
Figure 5. FCoE support not installed.
12