Configure The Fcoe Client Vlan; Figure 7. Selecting Fcoe Packages For Installation - Dell Wyse R Class Manual

Implementing FCoE in the Linux Operating System
Figure 7.
You may be prompted to accept any Automatic Changes to resolve dependency issues; if this
happens, select OK to allow the installation to proceed. After the packages install, you are
returned to the YaST2 Control Center. When finished, quit the YaST2 Control Center.

Configure the FCoE client VLAN

Next, configure the FCoE client VLAN by performing the following steps:
1. Start the YaST2 Control Center using the yast command, then select Network Services ,
and then FCoE Client Configuration , as in Figure 8.
Selecting FCoE packages for installation.
14