Figure 2. Results Of Show Fip-Snooping Enode Command; Figure 3. Results Of Show Fip-Snooping Fcf Command - Dell Wyse R Class Manual

Implementing FCoE in the Linux Operating System
Figure 2.
12. Verify that the Fibre Channel forwarder port is enabled and working correctly on the edge
switch. Run the following command from the edge switch command line while in EXEC mode
(see Figure 3 for results):
show fip-snooping fcf
Figure 3.
13. To verify on the Cisco Nexus 5020 distribution switch that your server is successfully
connected using FCoE, you can run the following commands in EXEC mode; see Figure 4 for
results:
show fcoe database
show lldp neighbors
Results of show fip-snooping enode command.
Results of show fip-snooping fcf command.
(this lists the vfcs and their respective active MAC address)
(this shows all external connections to the switch, their device
IDs, and their respective incoming ports)
10