Table of Contents
Advertisement
Chapter 2 - Installation
2.1.2 USB CONNECTION
1.
Connect the DSL cable (green) in to the DSL wall jack and the other end in to
receptacle marked "DSL RJ-11" on the back of the SMC7003ADSL.
2.
Connect the Power cord to the AC Power Adapter.
3.
Connect the AC Power Adapter to the AC wall output and connect the round cable
end to the "Power" receptacle on the back of the device.
4.
Turn ON the SMC7003ADSL by using the ON/OFF switch in the back of the device
to the ON position. You must have a steady (green) Power LED. The Sync LED will
be a blinking (green) LED initially and will become steady (green) once the
connection is established.
5.
Locate the USB port of the PC. It is marked with the typical USB symbol.
6.
Plug the square side of the USB cable's one end (grey cable) in to the
SMC7003ADSL device's USB port and the other flat long end to the USB port of the
PC. (If the PC is running, it will automatically detect the USB port Driver).
NOTE: aWindows NT 4.0 does not support USB.
aUSB port may have some compatibility issues with Windows 95.
Follow instructions on how to load the USB driver for the SMC7003ADSL (USB
7.
Installation - Section I. How to install the USB Driver).
SMC7003ADSL (version 1.0)
9
Advertisement
Table of Contents
