Adjusting The Video Channel - Sharp DV-NC85 Operation Manual

Adjusting the Video Channel

To view the output of your Product on the television screen, you must
select an unused channel on your TV and tune it to the output of your
Product (see Table 1 for factory preset to UHF Channel).
1
Make sure both Products (TV and this Product) are connected
(power cord) to the power outlet.
2
Turn on your TV.
3
Select an unused channel on your TV.
4
Set the power on the Product to off. (If the Product is ON, press
OPERATE to turn off the power.)
5
Keep pressing VCR MENU for more than two seconds to light up
the UHF Channel (see Table 1) on the VCR Front Panel display.
Table 1
South East Asia,
Hong Kong
Ex.
Australia
6
Adjust the tuning of the selected TV channel until the RF pattern
appears on your TV screen. (Refer to your Operation Manual for
tuning procedures.)
DVNC85(E)#014_022.p65
Factory Preset UHF Channel
60
37
Hong Kong and
RF
Southeast Asia models
SYSTEM I B/G D/K
(RF pattern)
RF
Australia model
SYSTEM B/G D/K
(RF pattern)
19
Hong Kong model
Southeast Asia model
Australia model
TIMER
OPERATE
EJECT
ON/OFF
ON VCR/DVD VCR MENU
DISPLAY
SCREEN SELECTOR DVD SETUP
FUNCTION PROG/ OPEN/
ZOOM
CONTROL REPEAT CLOSE
TITLE
DVD MENU
CLEAR SET
RETURN ENTER
ZERO BACK
SKIP SEARCH
KARAOKE
SELECT
AM/PM INPUT SELECT VCR DVD
/
REV FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE DPSS
SKIP SLOW
SPEED
AUDIO
CH
OUTPUT
VCR DVD
VCR/DVD COMBINATION
03.6.24, 9:49 AM
G-CODE
PROG
19
GB