Setting the channel
This VCR/DVD has a built-in tuner to receive TV
broadcast transmissions. Before you record a TV-
Broadcast, you must set and preset all available
channels. This VCR/DVD can preset up to 80 chan-
nels.
Preparation:
• Turn ON the TV and select its AV channel (this may
be labelled EXT / AUX etc.)
• Select "CHANNEL SETUP". For the procedure, see
steps 1 to 3 in "Using the SETUP MENU" on page
17.
SETUP MENU
TIMER REC SET
SYSTEM SETUP
CH TUNING
AV SETUP
AUTO TUNING
REC SETUP
CHANNEL SETUP
OTHER
SELECT
ENTER
ENTER
Automatic station presetting
Select "AUTO TUNING" and press ENTER.
The VCR/DVD will begin searching and storing all the
broadcasting channels available in your area. While this
is happening, "AUTO TUNING" will be shown on the
screen. When automatic tuning process is completed,
the screen will return to normal.
NOTES:
• TV reception interference or power failure may result
in Automatic station presetting malfunctions. In such
a case repeat the setting procedure from the begin-
ning.
If the automatic tuning procedure has problems re-
ceiving some stations correctly, you can try to preset
the station manually (See page 27).
• When the unit is in the auxiliary input mode, you can-
not preset channels.
26
GB
CHANNEL SETUP
PROCEED
PROCEED
RETURN
BACK
SETUP
END
To skip a channel position
Unwanted channels can be skipped so that they can-
not be called up by pressing CH
Example: Skip the channel position 29.
1
Select "CH TUNING" and press ENTER.
2
Select "CH" and press ENTER. Then select the
skipping channel position number (29) and press
ENTER.
29
CH
SKIP
OFF
DECODER
OFF
3
Select "SKIP" and press ENTER.
CH
29
SKIP
OFF
DECODER
OFF
4
Select "ON" and press ENTER. Now this channel
position is skipped.
NOTE: To cancel skipping, select "OFF" at step 4 above.
DECODER ON/OFF
You can set the DECODER setting for each channel
position.
Example: Set the channel position 5 as decoder on.
1
Select "CH TUNING" and press ENTER.
2
Select "CH" and press ENTER. Then select the
desired channel position number (5) and press
ENTER.
CH
5
SKIP
OFF
DECODER
OFF
3
Select "DECODER" and press ENTER.
CH
5
SKIP
OFF
DECODER
OFF
4
Select "ON" and press ENTER. Now this channel
position was set as decoder on.
NOTE: To set to decoder off, select "OFF" at step 4 above.
/
.