Setting the Channels
Your VCR can receive VHF channels 0 to 12, and UHF channels 28 to 69. Your VCR has 48 programmable
channel positions, each of which can be set to any of the above broadcast channels. The channel positions have
been preset at the factory as shown below.
AUTO TUNING
PREPARATION
Select the video channel on your TV. And turn on the VCR. (See page 5, item 3.)
l
If additional unwanted channels were found, refer to page 13 to skip unwanted channels
l
If some channels were unable to be found, refer to page 12 for Manual Tuning.
l
Use the A / 7 / 4 / F buttons on the remote control to set
l
the OSD.
Channel position numbers 1, 3. 4, 8, 11 to 27, and 29 to 46
l
have been factory set to be skipped when CHANNEL A
or V is used
If the picture is not clear, if you want a different channel
l
from the one preset or if you wish to reset a skipped
channel, reset the channel as follows
"CHANNEL PRESET" with A/V, and press
Select item "AUTO" with A/Y and press
CHANNEL PRESET has been preset to MANUAL at the
l
T h e c h a n n e l d i s p l a y o n the TV screen will c o n t i n u e
through all of the channels and when finished, the TV
screen will return to the normal screen.
bar display indicates the estimated amount of
The
channels tuned.
SET.
11