Introduction; Safety Is Important - Sharp LC-17SH1E Operation Manual

Introduction / Safety is Important

Introduction

Thank you for purchasing this product which has been designed and manufac-
tured to give you many years of trouble-free service.
You may already be familiar with using a similar product, but do please take
time to read these instructions - they have been written to ensure you get the
very best from your purchase.

Safety is Important

To ensure your safety and the safety of others, please ensure you read the
Safety Instructions before you operate this product.
Keep this information in a safe place for future reference.
This apparatus complies with the requirements of Council Directives 89/336/EEC and
73/23/EEC as amended by Council Directive 93/68/EEC.
SPECIAL NOTE FOR USERS IN THE U.K.
The mains lead of this product is fitted with a non-rewireable (moulded) plug incor-
porating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved
BS 1362 fuse marked
indicated on the pin face of the plug, must be used.
Always refit the fuse cover after replacing the fuse. Never use the plug without the
fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible with the
plug supplied, cut off the mains plug and fit an appropriate type.
DANGER: The fuse from the cut-off plug should be removed and the cut-off plug
destroyed immediately and disposed of in a safe manner.
Under no circumstances should the cut-off plug be inserted elsewhere
into a 13A socket outlet, as a serious electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue : Neutral
As the colours of the wires in the mains lead of this product may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows;
• The wire which is coloured blue must be connected to the plug terminal which is
marked N or coloured black.
• The wire which is coloured brown must be connected to the plug terminal which
is marked L or coloured red.
Ensure that neither the brown nor the blue wire is connected to the earth terminal in
your three-pin plug.
Before replacing the plug cover make sure that:
• If the new fitted plug contains a fuse, its value is the same as that removed from
the cut-off plug.
• The cord grip is clamped over the sheath of the mains lead, and not simply over
the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
2
or and of the same rating as above, which is also
Brown : Live