Input/Output - Ricoh 8025e Operating Instructions Manual

Copier / Document Server Features

Input/Output

This section describes the user tools in the Input/Output menu under Copier /
Document Server Features.
Default settings are shown in bold type.
❖ Switch to Batch
You can select to have Batch mode or SADF mode displayed when you press
the [Special Original] key.
The default setting is Batch.
3
❖ SADF Auto Reset
When you set one original at a time in the ADF, the Auto Feed indicator lights
for a specified time after an original is fed, to show the ADF is ready for an-
other original.
You can adjust this time from 3 to 99 seconds in increments of 1 second.
The default setting is 5 seconds.
❖ Rotate Sort: Auto Paper Continue
Specify to continue copying when paper of the required orientation has run
out during rotate sort.
The default setting is No.
• Yes
Copying continues using copy paper of a different orientation. The copy
job will finish even if you have left the machine.
• No
When paper of the required orientation runs out, the machine stops copy-
ing and prompts you to supply copy paper. After you have loaded paper,
the machine will continue copying.
❖ Auto Sort
You can specify whether the Sort function is selected when the machine is
turned on, or the functions are cleared.
The default setting is No.
❖ Memory Full Auto Scan Restart
When memory becomes full while scanning originals, the machine can make
copies of scanned originals first, and then automatically proceed scanning re-
maining originals.
The default setting is No.
• Yes
You can leave the machine unattended to make copies, but sorted pages
will not be sequential.
• No
When memory becomes full, the machine stops operation allowing you to
remove the copy pages delivered on the output tray.
90