Table of Contents
Advertisement
Symptom
Images do not appear
The power is not on. Or the LCD Monitor is dark.
on the LCD Monitor.
The AV cable is connected.
The screen display status is in [SYNCHRO-MONITOR
MODE].
It is set to [Power-Save].
The lens or A Window is dirty.
Although it is set to
Auto Focus, it does
The subject is not in the center of the shooting range. Shoot with Focus Lock.
not focus.
It is a hard-to-focus subject.
The Shooting Mode is set to R (Multi-Shot) or 3
The flash does not
fire. Or the flash can-
(Movie).
not recharge.
The flash is set to
The White Balance is set to something other than Auto
mode.
Batteries are running low.
Even though the flash
The distance to the subject is greater than 3.3 meters
fired, the picture is
in Telephoto or greater than 5.0 meters in Wide-angle.
dark.
The image is too
You are too close to the subject.
bright.
It is over-exposed.
The brightness of the LCD Monitor is odd.
The image is too dark. The shot was taken in a dark place while set to
(Flash Off).
It is under-exposed.
The brightness of the LCD Monitor is odd.
The image lacks nat-
The picture was shot in conditions that are hard for
ural color.
Auto White Balance to adjust to.
The date, or recording
The screen display function is set to No Display.
information does not
appear.
The brightness of the
You are using it in a dark place or when Auto Focus
LCD Monitor changes
range and surrounding brightness are different.
during AF.
There is a vertical
This is a phenomenon that occurs when a bright sub-
smear on the image.
ject is shot. It is called the smear phenomenon.
Cause
(Flash Off).
218
Measure
Turn the power on. Or adjust the brightness of the LCD
Monitor.
Disconnect the AV cable.
Press the DISP button and switch display.
Set [Power-Save] to off.
Wipe clean with a soft, dry cloth.
Shoot with Focus Lock or Manual Focus.
Switch the Shooting Mode to 5 (Still Image).
Set to Flash Off with the F button.
Set the White Balance to Auto mode.
If using alkaline batteries, replace with a new set.
If using rechargeable batteries, recharge or use the
AC Adapter.
Get closer to your subject and shoot.
Set to Flash Off with the F button.
Use exposure compensation. Cancel Exposure Time.
Adjust the brightness of the LCD Monitor.
Release the Flash Off with the F button.
Use exposure compensation. Set to Exposure Time.
Adjust the brightness of the LCD Monitor.
Add a white object to the composition. Or use Auto
Balance in a setting other than Flash shooting or Auto
Mode.
Press the DISP button and switch display.
This is normal.
This is normal.
Appendices
Page
P.16
P.127
P.100
P.24
P.123
-
P.38
P.38
P.75
P.51
P.51
P.60
P.12
P.13
P.14
P.51
P.51
P.57
P.82
P.127
P.51
P.57
P.82
P.127
P.60
P.24
-
-
Advertisement
Table of Contents
