Copy Of The Lighting Plate Instructions; Aeration Adjustment - Regency C34 Classic Owners & Installation Manual

NFPA 54, or Natural Gas and Propane Installation Codes, CSA B149.1. (Australia: A S5601-2004, New Zealand: NZS 5261)
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
or additional information consult a qualified installer, service agency or gas supplier.
A) This appliance has a pilot which must be lighted by hand, following the instructions below exactly.
B) BE FORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance
- Do not touch any electric switch, do not use any phone in your building
- Immediately call your gas supplier from a neighbors phone. Follow the gas supplier's instructions.
- If you cannot reach your gas supplier, call the fire department.
C) Us
repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D) Do not use this appliance if any part has been under water . Immediately call a qualified service technician to inspect the appliance and
to replace any part of the control system and any gas control which has been under water.
E) Thisappliance needs fresh air for safe operation and must be installed so there are provisions adequate combustion + ventilation air.
FOR UNITS NOT EQUIPPED WITH ELECTRIC SPARK:
1) Push in gas control knob slightly and turn clockwise
"OFF". Knob cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly. Do not force.
PILOT BURNER
VEILLEUSE
THERMOPILE
ELEMENT
THERMO-
ELECTRI Q UE
2) Wait five (5) minutes to clear out any gas. If you then smell gas
STOP! follow "B" in the safety information above on this label. If
you don't smell gas, go to the next step.
3) Tu rn knob on gas control counterclockwise
4) Pu sh in control knob all the way and hold in. Immediately push
black button on spark igniter until pilot lights. Continue to hold the
control knob in for about 1/2 minute after the pilot is lit. Release
knob and it will pop back up. Pilot should remain lit. If it goes out,
repeat steps 3) and 4).
If knob does not pop up when released, stop and immediately call
your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or gas supplier.
5) Tu rn gas control knob counterclockwise
6) Us e rocker switch to operate main burner.
This adjustment is performed by the installer and
is primarily used in installations at high eleva-
tions. Push in for a yellow fl ame, or pull out for
a bluer fl ame. The burner aeration is factory set
but may need adjusting due to either the local
gas supply or altitude.
®
Regency CLASSIC C34-3 Direct Vent Freestanding Gas Stove

COPY OF THE LIGHTING PLATE INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
to "PILOT".
to "ON".
TO TURN OFF GAS APPLIANCE
1) Turn off the flame switch.
2) Push in the gas control knob slightly and turn clockwise
3) Turn off all electric power to the appliance if service is to be performed.
You may shut off the pilot during prolonged non use periods to conserve fuel.
DO NOT REMOVE THIS INSTRUCTION PLATE

AERATION ADJUSTMENT

Caution: Carbon will be produced if air shut-
ter is closed too much.
Note: Aeration Adjustment should only be
performed by an authorized Regency
Installer at the time of installation or
service.
OPERATING INSTRUCTIONS
l
FOR ALL PROPANE UNITS AND
UNITS EQUIPPED WITH ELECTRIC SPARK BOXES:
to
1) Push in gas control knob slightly and turn to "PILOT" position.
OFF
2) Push in control knob all the way and hold in untilthe pilot lights
up. Continue to hold the control knob in for about 20 seconds
after the pilot is lit. Release knob.
3) Push in gas control knob slightly and turn to "ON" position.
4) Turn ON the flame switch.
to "OFF". Do not force.
INSTALLATION
1/
try to
. Keep burner
appliance.
918-474b
Natural Gas
Propane
®
5/16"
5/8"
35 35