Table of Contents
Advertisement
COPY OF THE LIGHTING PLATE INSTRUCTIONS
This appliance must be installed in accordance with local codes, if any; if not,
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life. Improper installation, adjustment,
alteration, service or maintenance can cause injury or property damage. Refer to the owner's
information manual provided with this appliance. For assistance or additional information
A) BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance
- Do not touch any electric switch, do not use any
phone in your building
- Immediately call your gas supplier from a neighbors
phone. Follow the gas supplier's instructions.
- If you cannot reach your gas supplier, call the
fire department.
CAUTION: Hot while in operation. Do not touch. Severe Burns may result. Due to high surface
temperatures keep children, clothing and furniture, gasoline and other liquids having flammable
vapors away. Keep burner and control compartment clean. See installation and operating
instructions accompanying appliance.
1)
Plug the power cord into a power outlet.
2)
Press and release the ON/OFF switch once to start
the unit. The LED will be lit.
1)
Press the ON/OFF switch once.
2)
The LED will flash.
You may shut off the pilot during prolonged non use periods to conserve fuel.
Part #: 918-247b (for FG38 & IG35 only)
Colours:
Black on Grey, except for parts in RED
Size:
100%
Feb. 9/06: no changes artwork.
16
Dec. 18/18: Rev.C updated standard + added wording
FOR YOUR SAFETY READ BEFORE LIGHTING
SUITABLE ONLY FOR INDOOR INSTALLATION
follow the current CAN1-B149/ANSI Z 223.1 AS / NZS 5601
consult a qualified installer, service agency or gas supplier.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
TO TURN OFF GAS APPLIANCE
DO NOT REMOVE THIS INSTRUCTION PLATE
DO NOT SPRAY AEROSOLS IN THE VICINITY OF
THIS APPLIANCE WHILE IN OPERATION.
OPERATING INSTRUCTIONS
B) Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
This appliance needs fresh air for safe operation and
must be installed so there are provisions for adequate
combustion and ventilation air.
3)
After approximately 8 seconds the spark ignition
system will spark for 8 seconds to light the main
burner.
4)
If the main burner does not light, repeat step 2 to
restart.
3)
Turn off all electric power to the unit if service is
to be performed.
WARNING:
Regency FG38 FireGenie Freestanding Gas Stove
918-247c
Advertisement
Table of Contents
