Primera Disc Publisher II User Manual page 10

Transporter will automatically check the Input Bin to make
certain that only one disc was picked.
Through software control, you can perform a test on each
disc before recording. If a disc does not pass (meaning that
all or part of that disc is not recordable), the Robotic Disc
Transporter picks it out of the CD Tray and sends it to the
Reject Area.
5. The Recorder is now writing to the disc. If you were to
fully record a CD with data, audio, video or music
(650 MB), recording time is about 3 fi minutes each.
A full DVD records in about 30 minutes. Most jobs don't
fill the entire disc, so recording time is usually less than
this. After recording, the Recorder Tray opens
automatically. The Robotic Disc Transporter will lift the
disc out of the Recorder Tray. The Recorder Tray will
close, and the Printer Tray will open. The Robotic Disc
Transporter will lower the disc into the Printer Tray, and
the Printer Tray will then automatically close.
6. If publishing more than one disc, the Robotic Disc
Transporter will load the Recording Drive with a blank
disc from the Input Bin to start recording the next round.
7. Once recording has started on the next round, printing will
start with the recorded disc from the previous round. This
simultaneous printing and recording greatly increases the
throughput of your Publisher.
8. Print time varies according to which print mode has been
selected (section 3-A). In most cases, print time takes no
6 Getting Started