Frymaster BIH52 Series Service Manual page 109

NOTE:
In September 1999, significant changes were made to the design of the filter base
assemblies used in BIH52 fryers. The most visible change was the removal of the casters on all
assemblies except 806-8804 (which is used in units manufactured for sale primarily in Japan). The
motor cover was also redesigned and a lower plumbing shield was added. Additionally, the two-
piece motor support (P/Ns 900-7469 and 900-7470) was replaced with a single, stronger support.
In order to provide continued support for units built prior to August 1999, a new filter base assembly
with casters (P/N 106-0043SP) was created to replace the original 806-5895 filter base assembly,
which is no longer available.
Two additional modifications to the design of the base sides have been made since August 1999.
These include the replacement of the die-cast metal handles with handles formed into the sides, and
the replacement of the separate lock brackets with brackets that are also formed into the sides.
ITEM PART #
1 900-5477
* 824-0558
2 900-1949
3 900-7557
4 900-9634
5 810-0949
6 806-9153
7 806-9150
8 823-2289
9 900-5396
10 826-1374
11 810-0180
12 826-1360
13 201-3770
14 202-3770
15 806-9154
16 806-9151
17 810-1211
18 900-1953
* 809-0440
* 826-1677
* Not illustrated.
Cover, Motor (September 1999 and later) (used with all three assemblies)
Cover, Motor (Prior to September 1999)
Standoff, Filter Wiring Box (used with all three assemblies)
Cover, Suction Tube (used with all three assemblies)
Shield, Filter Plumbing (used with all three assemblies)
Caster, 2.5-inch Swivel (also used in original 806-5985 assembly)
Side, Left Filter Base (used in 106-0043SP)
Side, Right Filter Base (used in 106-0043SP)
Support, Filter Pan (used in all three filter base assemblies)
Support, Filter Motor (used in all three filter base assemblies)
Screw, #10 x ½-inch Washer Hex Head (Pkg of 25)
Handle, Plated Die-cast Metal
Screw, 10-24 x 5/16-inch Round Slotted Head (Pkg of 25)
Side, Left Filter Base (used in 806-8648SP)
Side, Right Filter Base (used in 806-8648SP)
Side, Left Filter Base (used in 806-8804SP)
Side, Right Filter Base (used in 806-8804SP)
Caster, BIH52 Rigid (used in 806-8804SP only)
Bracket, Filter Lock (used on base assemblies prior to September 1999)
Nut, 5/16-inch Keps Hex (used for securing casters to base assemblies)
Pin Extension Kit
COMPONENT
4-38