3.3 Activating the Protocol
...from previous page
48
Press Set/Eject once.
Press
twice.
Press
once.
Press
once.
Starting the Protocol
Press Set/Eject once. The
name of the protocol is
displayed in the position of xxx.
Press
once.
Press Set/Eject once. The
following screen will be shown
three seconds after the
message "Reboot system to
take effect" is displayed.
To activate other protocols,
press Cancel once and proceed
to the following procedure.
Proceed to Step
setting is completed.
Switch off the printer, and then
switch it on again.
after the