Installing The Drum Cartridge; Connecting Interface Cable - Xerox DocuPrint C525 A Quick Reference Manual

Installing the Drum
Cartridge
WARNING
• Never throw a drum cartridge into an open
flame. It can cause an explosion and you can
get burnt.
1. When the "Load Drum Cartridge" message is
displayed on the control panel, open the front
cover, then lift and push back the top cover.
Note
• If the optional duplex unit is installed, first open the unit
D then the top cover.
2. Take the drum cartridge out of the packaging
box, and then remove the protective sheet.
Important
• Hold the drum cartridge by the handle. Do not touch the
surface of the drum (blue colored part). Also, never
allow any material to hit or rub the surface of the drum.
• Do not expose the drum cartridge to direct sunlight or
strong light.
• To ensure good print quality, always keep the drum
cartridge level when handling it.
16
1 Installing the Printer
Handle
3. To insert the drum cartridge, push up the
lever on the right side of the printer. With the
lever in the upright position, hold the drum
cartridge by the handle, align the arrows on
the drum cartridge with the corresponding
arrows on the printer and guide the cartridge
in until it snaps into place.
4. Pull down the lever on the right to lock the
drum cartridge in place.
Close the top cover, then close the front
cover.
Note
• When the unit D has been opened as in step 1, close it.
Important
• After installing the drum cartridge, the printer makes an
adjustment for about one to two minutes. Do not switch
off the printer during this time.
Connecting Interface
Cable
Connect the interface cable to be used to the
printer.
Connect a USB cable only after the print driver
has been installed on the computer.
1. Connect the interface cable to the interface
connector at the back of the printer.
Parallel
USB
Network
2. Connect the other end of the interface cable
to the computer or a LAN drop or hub.