Vodavi Starplus Triad-S Product Description Manual page 270

Messages - Custom
3. Enter the custom message using the dial pad keys to enter the letters
Conditions
as shown in Chapter 5,
Up to 24 alphanumeric characters may be entered for the custom
message (this represents 48 digits entered). The actual characters
display as the digits are being entered while programming the
messages.
The Attendant must go idle after programming a message before
another message may be programmed.
The Attendant then presses the HOLD button to enter the
message and a confirmation tone is heard.
The telephone receiving the message or programming must be a
display telephone.
Key telephones and SLTs can leave a message. SLTs are notified that
they left a message with a warning tone when going off-hook.
Incoming and outgoing calls are not inhibited with a message
displayed.
When a message is displayed by a key telephone, the DND button
LED flashes at the 15 ipm rate.
When DND is invoked on the telephone, the message is canceled.
Message Access (with desired message) may be assigned to a flex
button.
The Message Access function is assigned to a station flex button in
database administration.
A station user may store any of the available messages under a flex
button assigned as a Message Access button.
The ten Custom Messages display in a similar fashion as Canned
messages. The idle station display shows the message that was
activated at the station and a calling station receives the STA XXX or
name-in-display followed by the programmed custom messages.
This feature is not available for use at Attendant stations.
Figure 5-5: Other Key Pad Codes
7-19
(Name).