Remote System Monitor
4. Press <Enter> to enable the trace. A screen similar to the following displays:
5. To disable or turn off a particular trace mode, do not enter a specific board, CO Line or
Station Number (e.g., t<space>s<return> to disable station event trace).
To have event traces displayed on the screen, exit the MONitor mode by typing X at the
mon> prompt. After exiting the event(s), the trace begins as shown in
Modify Memory Command
The Modify Memory command is for engineering use only.
Figure 4-7: Enable Event Trace
Unless instructed by personnel at Vodavi Technical Support, do not leave the trace mode
enabled for extended time periods. The system dumps the requested event(s) trace which
may use up paper or fill memory buffers on the collecting device. It is recommended that
the trace events be disabled (turned off) for all event(s) traces before leaving the system
site unless otherwise instructed by Technical Support.
Using this command can alter or damage the
result in system malfunction. If this occurs, power the system down and re-initialize the database,
then completely reprogram the customer programming data.
Chapter 4 - Maintenance and Troubleshooting
Triad-S™
System operating database which can
4-17
Figure 4-8
.