4-22
Modify Memory Command
The Modify Memory command is for engineering use only.
Exit the Monitor Mode
The Exit command terminates the current Monitor enable/disable
session. If Event(s) Trace was or is still enabled, event records display only
after exiting the MONitor mode. The Exit command format is: mon> x
To have event traces displayed on the screen, exit the MONitor mode
by typing X at the mon> prompt. After exiting the event(s), the trace
begins as shown in
Unless instructedby personnelatVodaviTechnicalSupport, donot
leave the trace mode enabled for extended time periods. The
systemdumps the requested event(s) trace which may use up
paper or fill memory buffers on the collecting device. It is
recommended that the trace events be disabled (turned off) for all
event(s) traces before leaving the system site unless otherwise
instructed by Technical Support.
Usingthis command canalterordamage the
databasewhichcan resultinsystemmalfunction.If this occurs,powerthe
systemdownandre-initializethe database,thencompletely reprogram
the customer programmingdata.
Sta 100: State= DIAL_TONE, Evt= Dial Pad (25), Data=7
Sta 100: State= DIALING, Evt= Dial Pad (25), Data=5
Sta 100: State= DIALING, Evt= Int Page (69), Data=8
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=3
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=9
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=5
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=8
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=7
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=4
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=3
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=9
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=9
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=9
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=7
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=11
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=3
Sta 100: State= PAGING, Evt= Dial Pad (25), Data=2
Sta 100: State= PAGING, Evt= Page T/O (150), Data=0
Sta 100: State= MISC_TONE, Evt= Dial Pad (25), Data=4
Sta 100: State= MISC_TONE, Evt= Dial Pad (25), Data=9
Sta 100: State= MISC_TONE, Evt= Key Data (26), Data=32
Sta 100: State= MISC_TONE, Evt= Mon Key (145), Data=-1
Sta 100: State= MISC_TONE, Evt= On Hook (17), Data=0
Figure 4-8: Event Trace
Figure 4-8
.
Remote System Monitor
Triad-S
Systemoperating