Philips DVDR890/021 User Manual page 34

During installation, all available TV channels are searched for and stored. If the channel
assignments of your cable or satellite TV provider change or if you are reinstalling the DVD
recorder, e.g. after moving house, you can start this procedure again. This will replace the stored
TV channels with the new ones.
With Easylink, you can search for and store TV channels only on the TV set.
These settings are accepted by the DVD recorder. Use this function to start
the transfer of TV channels from the TV set.
1
Switch on the TV set. If required, select the programme number for
the DVD recorder.
2
Switch on the DVD recorder using STANDBY/ON .
3
Press SYSTEM-MENU on the remote control. The menu bar will
appear at the top of the screen.
4
' using D or C .
Select '
5
Select line '
6
Select line '
7
Press C .
8
The automatic TV channel search starts. This allows the DVD
recorder to save all available TV channels. This procedure may take
several minutes.
9
When the automatic search is completed, '
' will appear on the TV screen.
0
To end, press SYSTEM-MENU .
You can read about how to search for a TV channel manually in section 'Adding and clearing TV
channels manually'.
' using B or A and confirm with C .
' using B or A .
Installing your DVD recorder