Table of Contents
Advertisement
Connecting the DVD recorder
2
Insert one end of the supplied aerial cable into the TV socket at the
back of the DVD recorder and the other end into the aerial input
socket at the back of the TV set.
3
Plug a scart cable into the scart socket EXT 1 TO TV-I/O at the
back of the DVD recorder and the scart socket for the DVD
recorder at the back of the TV set (see TV set operating instructions).
Select the scart socket that is suitable for both video output and for video
input.
Select 'VCR' as the source for this scart socket.
4
Switch on the TV set.
5
Insert one end of the supplied mains cable into the mains socket
4MAINS at the back of the DVD recorder and the other end into
the wall socket. '
6
If the connection was properly made and your TV was
to the programme number for the scart socket, e.g. 'EXT',
'0', 'AV', you will see the following picture:
a
b Many TV sets are switched by the DVD recorder to the programme
number for the scart socket by way of a control signal sent through the
scart cable.
b If the TV set does not automatically switch to the scart socket programme
number, manually change to the corresponding programme number on your
TV set (see your TV's operating instructions).
b Check that the scart cable is connected from the TV set to the EXT 1
TO TV-I/O socket on the DVD recorder. The EXT 2 AUX I/O socket is
intended only for additional devices.
Then, read the paragraph on 'Initial installation' in 'Installing your DVD recorder'.
' will appear on the display.
Hide quick links:
Advertisement
Table of Contents
