What If The Projector You Want Does Not Appear - Epson EasyMP EMP-735 Setup Manual

Connecting in Access Point Mode

What If the Projector You Want does not Appear?

If the projector to which you want to connect does not appear on the projector
selection screen of EMP NS Connection, please check the following:
• Is the wireless LAN signal weak, or not being received at all?
• Is the connection mode set up correctly?
• Are the subnets different ?
When using Easy connect mode:
• Are the computer and projector setup with the same ESSID
• Are the computer and projector setup to use the same channel?
In the event that you are connecting the projector on a network where the subnets
differ, you can use "IP connect mode" to establish a connection.
IP connection mode works by using the IP address of the projector to establish a
connection.
Perform the following steps to connect using IP connection mode.
Tip :
The projector name will not be displayed in the projector selection screen of EMP NS
Connection if the projector's IP address and the computer's IP address belong to a
different subnet.
Caution :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card slot is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card
is lit green, or when connected to a network. Doing so may damage the wireless LAN
card.
1 This performs a connection setup between the projector and computer
in Access point mode.
2
On the computer select "Start" - "Programs" (or "All Programs") - "EMP
NS Connection" - "EMP NS Connection".
EMP NS Connection starts.
52
p.24
?