Connecting Using Easy Connect Mode; Before Connecting - Epson EasyMP EMP-735 Setup Manual

Connecting Using Easy Connect Mode

This section describes the steps necessary to project images from a computer using
Easy connect mode, perform operations when projecting images, and to disconnect.
Perform the following steps prior to projecting images.
1. Set up the Easy connect mode settings on the projector.
2. Set up the connection on the computer.
3. Start EMP NS Connection on the computer, and connect to the network.
Once these settings have been established, future sessions can begin by just
connecting the devices. When connecting to a network for the first time or when
settings are changed, refer to "Connection Settings on the Projector" (
the projector and computer connection settings are already established, refer to
"Connecting to a Computer" (

Before Connecting

Ensure that the following procedures have been carried out before connecting a
computer and projector via a network.
• Install EMP NS Connections on the computer you will be using.
• Prepare the computer settings to use either a wireless LAN card or
internal wireless LAN functionality. Set the WEP
the documentation for the wireless LAN card installed in the computer, or
the computer's documentation.
• The size of the projected image varies depending on the distance of the
projector from the screen. Decide where the projector should be placed to
allow the image to fit on the screen.
Distance" in the EMP-735 User's Guide.
• For optimal performance, set the screen resolution of the computer you
are using to XGA or lower with a colour depth of 16bit.
p.30 ).
See "Screen Size and Projection
p.24 ). If
p.19
to OFF. For setup, see
23