Frigidaire 316000635 Owner's Manual page 13

Oven Cleaning
(continued)
Figure 1
Figure 2
Note: If the oven is set to bake or broil,
and then the Temperature Control Knob
is set to CLEAN, it will not start the clean
cycle until START is pressed again.
Use care when opening
the oven door after the self-cleaning
cycle. Stand to the side of the oven when
opening the door to allow hot air or steam
to escape.
DO NOT force the oven
door open. This can damage the
automatic door locking system. Use
caution when opening the door after
the self-cleaning cycle is completed.
The oven may still be VERY HOT.
To Start the Self-Clean Cycle
The oven is programmed to run a 3 hour self-clean cycle.
1. Be sure the oven door is closed.
2. Turn Temperature Control Knob to CLEAN.
3. Push START.
4. If the door is left open, the "Lock" indicator light will flash, but the lock motor
and clean cycle will not start. As soon as the controls are set and the door is
closed, the motor driven lock will begin to close automatically and the "Lock"
indicator light will flash. DO NOT open the door while the light is flashing (it
takes about 15 seconds for the lock to close).
When the Self-Clean Cycle is Completed
1. The "Lock" indicator light will continue to glow.
2. Once the oven has cooled down for about 1 HOUR and the "Lock" indicator
light has gone completely out (and is not flashing), the oven door can be
opened.
To Start the Self-Clean Cycle
The oven can be programmed to run a 2 or 3 hour self-clean cycle. We recommend
a 2 hour self-clean cycle for light soils and a 3 hour cycle for average to heavy
soils (to assure satisfactory results).
To Set the Controls:
1. Be sure the oven door is closed.
2. Turn Temperature Control Knob to CLEAN.
3. Push START. "3:00" will appear in the display. (The oven will automatically
program a 3 hour clean cycle.)
4. If you want a 2 hour clean cycle, press the DOWN ARROW. "2:00" will appear
in the display.
5. If the door is left open, the "Lock" indicator light will flash and "dr" will glow
in the display, but the lock motor and clean cycle will not start. As soon as the
controls are set and the door is closed, the motor driven lock will begin to close
automatically and the "Lock" indicator light will flash. "CLn" will appear and
remain in the display until the cleaning cycle is completed or cancelled. DO
NOT open the door while the light is flashing (it takes about 15 seconds for the
lock to close).
6. Press START at any time during the self-clean cycle to review remaining
cleaning time.
When the Self-Clean Cycle is Completed
1. The time of day will appear in the display window and the "Lock" indicator light
will continue to glow.
2. Once the oven has cooled down for about 1 HOUR and the "Lock" indicator
light has gone completely out (and is not flashing), the oven door can be
opened.
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle:
1. Turn Temperature Control Knob to OFF.
2. Once the oven has cooled down for about 1 HOUR and the "Lock" indicator
light has gone completely out (and is not flashing), the oven door can be
opened.
13
(Figure 1)
(Figure 1)
(Figure 2)
(Figure 2)
(Figure 1 or 2)