Download Print this page

Frigidaire 316454912 Important Safety Instructions Manual

Frigidaire freestanding electric range installation instructions
Hide thumbs

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS FOR FREESTANDING ELECTRIC RANGE
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Clearances and Dimensions
1.
Provide adequate clearances between the range and adjacent combustible surfaces.
2.
Location—Check location where the range will be installed. Check for proper electrical supply, and the stability of the floor.
3.
Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level.
29 1/4" with
door handle
25-3/4"
48"
maximum
49"
door open
maximum
Fig. 1
*30" MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACE AND THE BOTTOM OF AN UNPROTECTED WOOD OR
METAL CABINET; OR 24" MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT LESS THAN 1/4" FLAME
RETARDANT MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015" STAINLESS STEEL, 0.024" ALUMINUM OR
0.020" COPPER. 0" CLEARANCE IS THE MINIMUM FOR THE REAR OF THE RANGE. FOLLOW ALL DIMENSION REQUIREMENTS PROVIDED
ABOVE TO PREVENT PROPERTY DAMAGE, POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOP AND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE LOCATED ABOVE
THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN BE REDUCED BY INSTALLING A
RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" BEYOND THE BOTTOM OF THE CABINETS.

IMPORTANT SAFETY INSTRUCTIONS

• A child or adult can tip the range and
be killed.
• Verify the anti-tip device has been
installed to floor or wall.
• Ensure the anti-tip device is re-engaged when the range
is moved to floor or wall.
• Do not operate the range without the anti-tip device in
place and engaged.
• Failure to follow these instructions can result in death or
serious burns to children and adults.
leveling leg
To check if the anti-tip bracket is installed properly, use both
arms and grasp the rear edge of range back. Carefully
attempt to tilt range forward. When properly installed, the
range should not tilt forward.
Refer to the anti-tip bracket installation instructions
supplied with your range for proper installation.
Tip Over Hazard
Range
Anti-Tip
bracket
Fig. 2
Fig. 3
exactly, a fire or electrical shock may result causing property
damage, personal injury or death.
Important Notes to the Installer:
Read all instructions contained in these installation
instructions before installing range.
Remove all packing material from the oven compartments
before connecting the gas & electrical supply to the range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
Important Notes to the Consumer:
Keep these instructions with your owner's guide for future
reference.
As when using any appliance generating heat, there are
certain safety precautions you should follow. These are
listed in the Use & Care Guide, read it carefully.
Be sure your range is installed and grounded properly by a
qualified installer or service technician.
Make sure the wall coverings around the range can
withstand the heat generated by the range.
To eliminate the need to reach over the surface elements,
cabinet storage space above the elements should be
avoided.
1
30"
If the information in this manual is not followed
p/n 316454912 rev C
Español - Páginas 5-8

Advertisement

loading

  Related Manuals for Frigidaire 316454912

  Summary of Contents for Frigidaire 316454912

  • Page 1: Important Safety Instructions

    Provide adequate clearances between the range and adjacent combustible surfaces. Location—Check location where the range will be installed. Check for proper electrical supply, and the stability of the floor. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level.
  • Page 2: Before Starting

    1a. Locate the Bracket using the Template - may be located on either the left or right side of the range. Use the information below to locate the bracket if template is not available).
  • Page 3: Power Cord Connections

    (14-50R) existing installations receptacle (10-50R) Fig. 8 NOTE: Range is shipped from factory with 1-3/8" dia. hole as shown. To use either 7/8" dia. hole or 1-1/8" dia. knockouts refer to Fig. 9. Fig. 9 Fig. 10 4A.
  • Page 4 (Neutral) to the range chassis. The ground strap is connected to the range by the center, lowest screw (See Fig. 13). The ground strap must not be removed unless National, State or Local Codes do not permit use of a ground strap.
  • Page 5: Instrucciones Importantes De Seguridad

    INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA DE 30" LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: CONSERVE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y CONSERVE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. Espacios Libres y Dimensiones Provea espacios libres adecuados entre la estufa y las superficies combustibles adyacentes.
  • Page 6 INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA DE 30" ANTES DE COMENZAR Herramientas Necesarias Para los tornillos niveladores y soporte antivuelco: • Llave ajustable o pinzas ajustables • Llave de tuerca de 5/16" o destornillador de punta plana • Taladro eléctrico y broca de 1/8" de diám. (broca para taladro de mampostería si está...
  • Page 7: Conexión Tetrafilar

    INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA DE 30" Consulte la Tabla del Tamaño de la Abertura de Conexión de la Estufa (Figs. 9 y 10) para la información sobre los amperes del juego de cordón. Los bornes en los extremos de los almabres deben ser de anillo cerrado u horquillas abiertas con extremos dirigidos hacia arriba.
  • Page 8 INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA DE 30" o 4B. CONEXIONES DEL CORDON DE ALIMENTACION Instrucciones para conexión trifilar (para instalaciones existentes SOLAMENTE - Consulte la Fig. 13). Siga las instrucciones de instalación del fabricante suministradas con el sujetacable e instale (Además vea las Figs.

This manual is also suitable for:

Ei30ef55gsEw30ef65gsCei30ef5gsDgef3031kbFef369hcEi30ef35js ... Show all