NEC Storage Manager User Manual page 41

Step 7. Unmounting MV (business server)
You must create a perfect static point of MV data.
This is for writing the metadata of the file system completely to the disk. This is also for suppressing
I/O to the logical volume to keep data consistency of MV and RV.
To keep data consistency of MV and RV, unmount MV after stopping operation, and cancel association
between the volume and file system.
To execute unmount, you must quit all application software which access the drive. Also refer to the
description about unmount in Chapter 3 "Notes".
If MV unmounting failed and no means of avoidance exists, wait for 60 seconds and proceed to step 8.
In addition, although separating is allowed without unmounting in this step, unmounting upon
replication and restoration is mandatory.
iSMrc_umount -drv G:
Then, the following message is displayed and MV is unmounted.
Umount Start
disk10
\\?\Volume{822575dd-63d9-11d5-b1e0-009027520bce}\
G:
Umount Normal End
disk10
\\?\Volume{822575dd-63d9-11d5-b1e0-009027520bce}\
G:
Step 8. Executing Separate (business server)
Execute Separate to separate MV and RV to make RV available, and resume applications.
This example uses the replication file and separates MV and RV according to the following settings.
• Copy range: Difference (default value)
• Update reflection to RV: Sync mode (default value)
• Access restrictions for RV after Separate: rw (Read/Write) (default value)
• Specify the wait for Separate completion
iSMrc_separate -file disks.txt -wait
Chapter 2 Operation and Maintenance
2001/02/21 12:23:15
dev001
2001/02/21 12:23:15
dev001
35
WN
WN