Chapter 1 Installation Procedure; Installation Procedure - NEC Storage Manager User Manual

Chapter 1 Installation Procedure

This chapter describes the system installation procedures showing an example of a tape backup system that uses
the 2000 series disk array subsystem.
1 . 1
1 . 1
1 . 1
Installation works are outlined below. For details of the procedures, refer to the associated sections.
1. Determining the system
configuration
Select necessary hardware
configuration.
Select necessary software
configuration.
2. Installing software
Install/uninstall/update iSM
Install/uninstall/update
ReplicationControl
3. Determining the disk array
configuration
Select necessary logical disk
(LD) configuration.
Assign an identification name to
the management target
hardware.
Set AccessControl according to
the connection state.
Unlock the product license.
Configure a pair.
4. Setting a control volume
Only when a control volume is
used
5. Creating the volume list
6. Preparing volumes
7. Preparing the start of operations
I n s t a l l a t i o
n
I n s t a l l a t i o n
I n s t a l l a t i o n
Chapter 1 Installation Procedure
P r o c e d u r e
P r o c e d u r e
P r o c e d u r e
1.2.1 Hardware Configuration
1.2.2 Software Configuration
1.3.1 Replication Management
1.3.2 ReplicationControl
1.4.1 Logical Disk (LD) Selection
1.4.2 Setting of Disk Array Name,
Logical Disk Name, and Port Name
1.4.3 AccessControl Setting
1.4.4 Product License Unlocking
1.4.5 Pair Configuration Setting
1.5 Control Volume Setting
1.6 Volume List Creation
1.7 Preparing Volume
1.8 Preparation for Operation
1